STAGE 1 | 150KW

NISSAN PATROL Y61 3.0L | STAGE 1 | 150KW

The Patrol Y61 3.0L Stage-1 upgrade starts with our trained technician setting your vehicle up on our 4WD dynamometer and performing a baseline dyno run. This allows us to firstly make sure everything is working A-OK and secondly it gives us standard figure from your car to compare to once the upgrade is completed. We then commence the upgrades fitting a Process West SEPR8R air oil separator to capture oil mist entering your engine's inlet manifold which can build up in your engine's intake and cause a carbon build which can reduce the engine's reliability and performance over time. We then install a Turbosmart wastegate actuator to improve the turbochargers response and to improve boost stability.

We complete the package by custom tuning your vehicle's ECU on the dyno in real time utilizing the latest ECU tuning software to maximize power, torque and fuel efficiency and testing your vehicle on the road to make final adjustments, optimizing your vehicle's performance and driveability. At the end of this upgrade, we will provide you with a dyno graph comparing the before and after power & torque increase the upgrade has made to your vehicle.

Like all of our upgrade packages the Stage-1 package is modular in that it allows the customer to add to the package minimising the requirement to spend money twice when and if further upgrades are desired. We also always strive to bring you maximum performance with high quality components while still maintaining reliability and driveability.

Turbosmart wastegate actuator - A wastegate is a valve that controls exhaust gas flow from an engine to the turbocharger, it controls exhaust gas flow to the turbocharger’s turbine. Moreover, the wastegate can control the boost pressure provided by the turbocharger to the engine. The wastegate needs to be correctly matched for the engine and turbocharger combination, giving the end-user adequate control over boost pressure. 

Turbosmart Upgraded Wastegate Actuators have been developed to provide maximum possible boost response for your factory frame turbocharger. The Turbosmart IWG75 Series of upgraded Actuators benefit from an increased ‘Working Ratio’ over the factory equipment resulting in improved boost response, throughout the RPM range. This Improved ‘working ratio’ is achieved through an increase to the effective surface area of the diaphragm & revisions to the actual springs fitted resulting in greater leverage of the forces the actuator is working against (boost and backpressure) while still being super-responsive. 

Upgrading with the same base pressure as factory, you can expect a broader boost & torque curve through peak boost being achieved earlier in the RPM and being held longer, into higher RPM. These improvements can be amplified with higher base pressures; however tuning & recalibration is likely required.

Package Includes

1 x Turbosmart wastegate actuator
1 x Custom ECU reprogram
1 x Before and after dyno graph
1 x Labour to fit, tune and test

Key Features

Stage 1 addresses reliability and engine longevity issues, while delivering you better throttle response with a noticeable increase in power and torque.

Notes

• Power figures listed are estimated kilowatts at the flywheel based on results typically obtained by HPF on HPF’s dynos and are based on a automatic vehicle with standard driveline and standard wheels and tyres. Actual power can vary based on each specific vehicle.
• We advise against increasing the power output substantially on high kilometer engines, if your engine has in excessive of 150,000kms please contact us to discuss options.
• Whilst every attempt is made to ensure prices listed online are correct, they are subject to change at any time.
• Additional parts may be required in some cases depending on the condition of the vehicle. Cost of these parts and additional labor required may incur additional cost.
• Images are for illustration purposes only.

Enquire Here